Hammer PWR

The ideal solution for the largest of systems featuring many power-hungry analog/digital modules or modules which draw a lot of current needed for their ensured smooth operation. The Hammer PWR filters protection on the inputs and outputs of the power supply and stays in place with minor tweaks to its core design making sure that your system will keep operating under hassle-free, low-noise, artifact-free conditions while also being protected from noises present in the power grid at times so your system and modules are safe and intact from external occurrences, mishaps, and influences.

To ensure the lowest possible noise within your system Konstant Lab has used a special type of converters with low noise on their outputs and has split the +12V / 5A power branches by 2,5A + 2,5A to further decrease the inherent influence between modules. Two sets of output terminals then further elevate the stress of cables connected to the bus board for longer service life.

HammerPWR needs to be externally powered from a 120W power brick to make sure you and your modules are safe as well under all conditions.

The small dimensions of HammerPWR make it an ideal choice for any system including skiff and DIY where depth and size can be your concern.

Easy to install push to connect system – WAGO 256 series shockproof + push to connect terminals ensure easy installation of HammerPWR within your case.

Technical Details

Output Power – 100W

Outputs – +12/5A (Split to two branches 2.5A + 2.5A

Input – 20V DC

Output Connectors – 8 x WAGO spring terminals // 16 pin IDC for flat cable

Input Connectors – WAGO spring terminals // Panel with 5.5 X 2.5 DC input

Protections – Input filter // Input Overvoltage // Input reverse polarity voltage protection // Output overvoltage // Output short circuit – automatic recovery // Output over current – automatic recovery // All output pretections are independant for each rail

Efficiency – 90%

Other –  Dual input common-mode LC filter with high efficiency of cancelling noise and interference from input connector. Additional input filter for each converter for minimal output noise and interferences
LEDs indicate present and drop of output voltage. +12V output is split into two branches for modules separation and minimalise voltage dropout.

Accessories – Aluminium panel with 5,5 x 2.5 DC input (centre positive), power switch and two 25cm wires //  Screws 2.9 x 13mm 6pcs // Spacers 3mm height 4pcs