Used for fixing TipTop Audio Zeus Studio Bus Power into Eurorack cases.
Note: this KIT is not required if you order your power with your SynthRacks Eurorack case as all Stuidio Bus boards will be fully installed for you.
Installation Kit 1
For 1x Zeus StudioBus consists of 6mm stand off spacers, M3 screws to secure the Bus Board, plastic cable ties and anchor tabs , and a correct sized drill bit suitable to drill a pilot hole to enable you to screw the  spacers into the case.
Installation Kit 2
Kit 2. For 2x Zeus StudioBus consists of 6mm stand off spacers, M3 screws to secure the Bus Board, plastic cable ties and anchor, and a correct sized drill bit suitable to drill a pilot hole to enable you to screw the spacers into the case. Red and Green coated 16 AWG wire –sufficient for up to 2 StudioBus boards.
Installation Kit 3
For 3x Zeus StudioBus consists of 6mm stand off spacers, M3 screws to secure the Bus Board, plastic cable ties and anchor, and a correct sized drill bit suitable to drill a pilot hole to enable you to screw the spacers into the case. Red and Green coated 16 AWG wire –sufficient for up to 3 StudioBus boards.
Michael wilde (verified owner) –
Missing